Dwyer’s wide selection extends to Gages, Transmitters, Switches, Data Loggers, and Monitors for Differential Pressure. Dwyer manufactures a range of dial and digital gages to reliably measure and display pressure difference, between two pressure sources using gas or liquid in a process flow.
Gages Pressure, flow and piston-type gages are all found within this category. Clean design, small size and low cost with enough accuracy for all but the most demanding applications, these gages are the best around. Gages are indicators for the difference between two pressures or simply a single pressure. View More
Gage / Switches, Digital Digital indicators are for the difference between two pressures. The Gages and Switches are ideal for pressure, velocity, flow applications and single pressure. Products have Modbus communications and are 3 in 1 instruments. With features packed into 1 product, the Digihelic® controller is the only instrument for your pressure applications. View More
Switches Sensors for air and non-combustible compatible gases have an electrical contact output at a specific difference between two pressures. Applications vary between the different types of differential pressure switches. A wide variety of switches and circuit styles enables control functions needed for any system. View More
- How will installation of a Magnehelic® gage 150' away from the pressure source affect accuracy?
- Accuracy will not be affected, but response time will be increased in proportion to the length of the tubing.
- Which Capsuhelic® gage ports could be connected to the pressure source in liquid service?
- The bottom ports. This allows bleeding of entrapped air from the top ports to eliminate reading error due to compression of entrapped air in the gage. Bleed fittings should be installed in the top ports.
- Can the standard Magnehelic® or Capsuhelic® gage be installed outdoors?
- Yes. Front covers are sealed with "O" rings. Capsuhelic vent holes are plugged with foam, and the new high impact acrylic lens material is very resistant to ultra-violet fogging. Additional care is recommended to lead pressure connections downward from the gage and provide as much protection from the elements as possible
- Can a standard Magnehelic® gage be used for natural gas or propane service?
- No. As the silicone diaphragm will be attacked by these gases. A Buna-N diaphragm should be specified.
- What happens when a Magnehelic® gage equipped with the low temperature option is operated below -20 degrees Fahrenheit (-29 degrees Celsius)?
- Below that temperature the accuracy of the gage deteriorates beyond our published specification due to stiffening of the diaphragm.